Operation Manual

21
Step 2: Setting the date and time of day
The firmware version number will be displayed briefly once
you have inserted/replaced the batteries and then you will be
automatically prompted to set the date and time of day.
Use the setting wheel (B) to set •
the year (A).
Confirm with OK (C).•
Use the setting wheel (B) to set •
the month (A).
Confirm with OK (C).•
Use the setting wheel (B) to set •
the day (A).
Confirm with OK (C).•
Use the setting wheel (B) to set •
the hour (A).
Confirm with OK (C).•
Use the setting wheel (B) to set •
the minute (A).
Confirm with OK (C).•
The motor will start moving back the control pin while the
entries are still being made.
If “INS” is displayed with a rotating “•
∏ ” symbol, this
indicates that the motor is still moving back. Once the
device is ready for the actuator to be installed on the
valve, just “INS” will appear on the display.
The weekly program and other settings can be cus-•
tomised prior to installation. To do this, press the menu
button when “INS” is shown on the display. For further
details, please see “4. Configuration menu”.
O n c e p r o g r a m m i n g i s c o m p l e t e , “ I N S ” w i l l r e a p p e a r o n t h e •
display and installation (Step 3) can commence.