Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
98
The RTP Settings – Edit Entry page offers a drop down list and
a checkbox.
Packetization Interval
contains possible values (in
milliseconds) to be configured for the selected codec.
The Enable Silence Suppression checkbox selection enables
voice activity detection for the selected codec.
Fig. II-169: RTP Settings - Edit Entry
To Edit Codec Parameters
1. Select the codec from the Codecs Table that is to be edited.
2. Press the Edit button on the RTP Settings page. The Edit Entry page will appear in the browser window.
3. Change values in Packetization Interval and/or enable/disable Silence Suppression.
4. To save the codec settings press Save, or to keep the initial data click Back.
NAT Traversal Settings
The NAT Traversal Settings page is divided into separate pages used to configure General NAT settings, SIP NAT parameters, RTP and STUN
parameters for NAT and a page where the NAT Exclusion table may be filled.
The General Settings page consists of a manipulation radio
buttons group to select the mode of the NAT Traversal usage for
the SIP traffic (any incoming and outgoing SIP messages from
and to the Quadro will be routed through the NAT PC).
• Automatic –
with this selection, system will analyze the
Quadro’s WAN IP address and if it is in the IP range
specified for local networks (according to RFC), the SIP
traffic will be routed through NAT. Otherwise, if Quadro’s
WAN IP address is outside the specified IP range, no SIP
traffic will be routed through NAT server.
• Force – with this selection, all the SIP traffic will be routed
through the NAT server.
• Disable – with this selection, no SIP traffic will be routed
through the NAT server.
Fig. II-170: General NAT traversal page
The SIP Parameters page is used to configure NAT specific settings for SIP and offers two independent groups of settings:
UDP Parameters:
Manipulation radio buttons allow you to select the type of
connection over NAT:
Selecting Use STUN will switch to automatic discovery of
Mapped settings for the SIP UDP traffic over NAT. STUN
settings are configured on the STUN parameters page (see
below).
Selecting Use Manual NAT Traversal allows you to manually
define the mapped settings for the SIP UDP traffic over NAT:
Mapped Host requires the IP address of the mapped host for
SIP UDP traffic over NAT.
Fig. II-171: SIP Parameters page
Mapped Port requires the port number on the mapped host for the SIP UDP traffic over NAT.
TCP/TLS Parameters:
Mapped TCP Host requires the IP address of the mapped host for SIP TCP traffic over NAT.
Mapped TCP Port requires the port number on the mapped host for the SIP TCP traffic over NAT.
Mapped TLS Host requires the IP address of the mapped host for SIP TLS traffic over NAT.
Mapped TLS Port requires the port number on the mapped host for the SIP TLS traffic over NAT.
The RTP Parameters page is used to choose between the STUN and Manual NAT traversal connection for the RTP traffic and to define the
RTP/RTCP ports for the connection over NAT.
Manipulation radio buttons allow you to select the type of connection over NAT:
Selecting Use STUN will switch to automatic discovery of Mapped settings for the RTP UDP traffic over NAT. STUN settings are configured on the
STUN Parameters page (see below).