Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
53
8. Licensing
This page is only available if the corresponding licensing is
enabled from the
Features page.
This group allows you to configure the extension to be used by
the Quadro Communication Manager (QCM) soft-phone
application and the Pro/Basic level Desktop Communication
Console (DCC).
The page contains the following components:
Enable QCM (Quadro Communication Manager) license
checkbox which allows you to set the corresponding extension
to be used by the QCM application. When the checkbox is not
selected on this page, the QCM will be functional with the
extension only during trial period.
Enable DCC Pro license checkbox which allows you to set the
corresponding extension to be used by the DCC Pro level
application. When the checkbox is not selected on this page, the
DCC will be functional with the extension only during trial period.
Enable DCC Basic license checkbox which allows you to set
the corresponding extension to be used by the DCC Basic level
application. When the checkbox is not selected on this page, the
DCC will be functional with the extension only during trial period.
Fig. II-94: Extensions Management - Edit Entry – License Settings page
Please Note: These checkboxes can be simultaneously selected on as many extensions as DCC and/or QCM licenses are available on the Quadro.
Enable iQall Toggling license checkbox allows you to allocate the iQall Toggling licenses to the corresponding extensions.
The Go to User Settings link is used to make a quick jump to the extension specific Extension's Main Menu page (see Manual III – Extension User’s
Guide).
The Go to Line Settings link is used to make a quick jump to the
Line Settings page of the corresponding extension.
The Go to Codec Settings link is used to make a quick jump to the
Codec Settings page of the corresponding extension.
Pickup Group Extension Settings
Pickup Group & Access List
The Pickup Group service is used to monitor calls addressed to a certain list of extensions and to pick up calls ringing on the listed extensions. This
service may be used when a group of extensions are located in the same area so the persons nearby can hear the ringing on one of the extensions.
This feature allows you to pick up the call ringing on a certain extension by dialing the number of the pickup extension.
The Pickup Group list is used to define the extensions that can be monitored by calling a certain pickup extension.
The Access List is used to define PBX, SIP or PSTN users that are allowed or forbidden to intercept calls ringing on extensions in the Pickup
Group.
If a user dials the pickup extension when several extensions of the pickup group are ringing, the first (oldest in time) call will be picked up. When the
user dials the pickup extension and no extensions of the pickup group are ringing, the “No call is available to pickup” message will be played to the
user. When the user that is not listed in the Access List dials the pickup extension, password authorization (of the pickup extension) will be required
to answer the call. When a denied user dials the pickup extension, the “Party does not accept your call” message will be played to the user.
For Pickup Group extensions, the Extensions Management - Edit Entry page consists of General Settings, SIP Settings and Advanced SIP
Settings pages. The SIP Settings and Advanced SIP Settings pages are the same as for regular extensions (see
User Extension Settings)
described above. The General Settings page has a different content as follows: