Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
47
This page contains the following functional buttons:
Add functional button opens an Add Entry
page where
extensions may be added to the Call Barge In / Intercept
Access List.
This page requires the extension number in the
Address text field that will be allowed to intercept calls. The
wildcard is supported in the Address field to add a group of
extensions with one entry.
The checkboxes on this page allow to select one or more
options of the
Barge In Service and Call Intercept for the
extension:
• Allow Listen In
• Allow Whisper
• Allow Barge In
• Allow Intercept
Attention: Barge In/Call Intercept service calls are not
displayed in Active Calls table on the
Administrator’s Main
Page, nor are registered in the Call Statistics.
Fig. II-84: Call Barge In/Intercept Access List
Fig. II-85: Call Barge In/Intercept Access List - Add Entry
Watch Access List
The Watch Access List
page is used to define a list of
extensions that are capable to watch the current extension calls
and to define the appropriate permissions.
This page contains the following functional buttons:
Add functional button opens the Watch Access List - Add
Entry page where extensions may be added to the Watch
Access List.
The Watch Access List - Add Entry
page consists of the
following components:
• Call Type lists the available call types:
PBX - local calls to Quadro's extensions.
SIP - calls through a SIP server.
Auto - used for undefined call types.
The destination (independent on whether it is a PBX number or
a SIP address) will be reached through the Call Routing Table.
• The Address text field is used to define the address where
the call will be redirected. The value in this field is strictly
dependent on the Call Type defined in the same named
drop down list. If the PBX
call type is selected, the Quadro
extension number should be defined in this field. For the
SIP call type, the
SIP address should be defined. For the
Auto call type, a routing pattern needs to be defined. The
SIP-Clipboard button at the end of the line can be used
only when SIP is selected in the Call Type drop down list.
It opens a small window where one of the previously
entered 10 SIP addresses can be automatically selected
again. If the address already exists in the table, selecting
Save will cause the error "Caller address already exists".
Wildcard is allowed in this field.
Fig. II-86: Watch Access List page
Fig. II-87: Watch Access List - Add Entry page
The checkboxes on this page allow to select one or more options of the Watch Access List for the extension:
• Allow Presence Subscriptions