Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
35
System Contact text field requires optional information about
the contact person responsible for the SNMP management in
the defined network. Field may indicate the point person’s name,
email address, phone number or other contact information.
Enable SNMP v1 / 2c checkbox is used to enable SNMP v1/2c
protocol version for the messaging between Quadro’s SNMP
agent and the administrating application. If this checkbox is not
selected, SNMP v1 will be implied.
SNMP v1 / v2c Read-Only Community text field is used to
insert the community description (public, private, etc.) for the
read-only management (like gathering information (events,
statistics, etc.) about Quadro’s). Field may contain some kind of
password which should be matching both on Quadro and on the
administrating application for successful SNMP management.
Enable SNMP v1 / 2c Read-Write Access checkbox
additionally enables a read-write access on the Quadro for the
SNMP monitoring application. With this checkbox enabled,
administrator will be able to remotely configure the Quadro via
SNMP administrating program.
SNMP v1 / v2c Read-Write Community text field is used to
insert the community description (public, private, etc.) for the
read-write management (like gathering information (events,
statistics, etc.) about Quadro’s and remotely changing Quadro’s
configuration). Field may contain some kind of password which
should be matching both on Quadro and on the administrating
application for successful SNMP management.
Fig. II-59: Global SNMP Settings page
The Service Restart button restarts the SNMP sub-system on the Quadro. Restarting the SNMP sub-system is recommended if it does not respond
to a SNMP manager's requests.
SNMP Trap Settings are used to define the traphosts that
should be informed when certain events occur on the Quadro.
For the listed traphosts to be informed about the events on the
Quadro, Send SNMP Trap action should be configured for the
corresponding event(s) from the
Events page.
SNMP Trap Settings page contains a list of all configured
traphosts with the referring information.
Fig. II-60: SNMP Trap Settings page
Add functional button is used to add a new traphost to the table
and opens Add SNMP Traphost page where the new traphost
might be defined. Page consists of the following components:
Traphost text field requires an IP address or the host name of
the traphost. Administrating application’s host address should be
inserted here.
Community text field requires community description (public,
private, etc.) for the administrating application to accept the
notifications about the certain events on the Quadro. Field may
contain some kind of password which should be the same both
on Quadro and on the administrating application for successful
SNMP management.
A group of radio buttons is used to select the SNMP protocol
version used for events notifications delivered by the Quadro to
the administrating application.
Fig. II-61:Add SNMP Traphost page
Diagnostics
The System Diagnostic page gives a possibility of running Network and WAN protocol diagnostics to verify Quadro's connectivity and to download
all system logs for possible problems recovery.
The Start Detecting WAN Protocol button is used to initiate WAN diagnostics that will detect the WAN IP configurations: static or through DHCP
and PPP servers. For static WAN IP configuration, gateway availability is checked. When acting as a client, DHCP and PPP servers' accessibilities
are being verified.