Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
33
If you have confirmed the firmware version, a new page
with firmware update progress will be displayed next.
There are no functions available on this page, just
information about the firmware update procedure. At some
point the connection with the device is being lost and you
need to wait until the firmware will be burned on the
Quadro.
You will not be automatically redirected to the Login page.
To access the Quadro’s Web GUI, you need to connect
Quadro again and login.
Attention: After the firmware update, all IP phones
attached to the Quadro should be restarted.
Fig. II-56: Firmware Update page
Automatic Firmware Update
The Automatic Firmware Update page allows you to configure an automatic update of the Quadro’s firmware (software image) as it becomes
available on the server. When this service is enabled, on the configured day and time Quadro will automatically check for a new available firmware
on the server and will either notify the administrator or update the firmware right away, depending on the configured settings.
The server configuration can be done manually or through the DHCP server. In case of DHCP server replying configuration, the corresponding
adjustments should be done on the DHCP server to automatically point the Quadro to the destination where the firmware is stored.
Please Note: Independent on the selected server type, there should be an “auto-update” folder in the root directory of the server. Quadro will check
for any new firmware in that specific folder only. Besides the firmware *.bin file, the “auto-update” folder should contain supplementary file(s) to point
to the correct firmware file.
The detailed instructions on the functionality of automatic firmware update as well as server configuration are described in the “Automatic Firmware
Update” document which you can find at the Epygi Web support portal.
This page consists of the following components:
The Enable Automatically Firmware Update checkbox selection enables the automatic firmware update service on the Quadro.
Attention: When the older firmware is installed on the Quadro, the system configuration will be lost and the device will be factory reset.
The first manipulation buttons group on this page allows you to choose between the manually configured firmware server and the server defined by
the DHCP server.
• Assign manually – this selection is used to manually configure the firmware server settings. The Server Name (the IP address or hostname),
the Server Port and the Update Method should be defined. The Update Method drop down list provides a possibility to choose among TFTP,
FTP, HTTP or HTTPS methods. For some of these selections, authentication Username and Password can be entered.
• Assign automatically via DHCP - choose this selection if the Quadro acts as a DHCP client in its WAN interface. In this case the firmware
server’s configuration will be automatically obtained from the DHCP server. This selection requires previous configuration on the firmware
server and will work only if the “auto-update” directory is created on the TFTP server. The DHCP server should also be configured to provide
the "TFTP server name" parameter (option 66) to the Quadro.
The second manipulation buttons group on this page allows you
to select the frequency of checking for a new update.
• Check and notify – choose this selection if you only
wish to be notified about the new available firmware
on the server. With this selection, on the indicated
weekday and time, on daily or weekly basis, the
Quadro will check for a new firmware available on the
server. The way of notification is configured from the
Events page.
• Check and update – choose this selection to check
and automatically install the new firmware on the
Quadro as it becomes available on the server. With
this selection, on the indicated weekday and time, on
daily or weekly basis, the Quadro will check for a new
firmware available on the server, will automatically
download and install it on the Quadro.
The Check/Update Now button is used to manually initiate
Check and notify or Check and update actions. The action to
be executed depends on the radio button selected above.
Fig. II-57: Upload Configuration page