Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
32
Please Note: Installing new firmware will take about 15
minutes. During this time, Quadro, telephony and Internet
access will be disabled.
The firmware update will cause the loss of the following
data:
• All internally stored voice mails and custom voice
messages
Please Note: If you do not wish to lose your voice data,
have it downloaded from
Configuration Management page
prior to starting the Firmware Update.
• DHCP leases
• Transfer statistics
• Call statistics
Please Note: If you consider the
Call Statistics entries in
the displayed tables to be important, it is recommended to
download them from the corresponding page prior to
starting the Firmware Update.
Fig. II-53: Firmware Update page
• All pending events
• User specific GUI states
The following main processes will be stopped during the firmware update and will be restarted after the installation is completed:
• Voice Software
• Network Time Protocol Daemon
• Network Interface Statistic Daemon
• Dynamic DNS Daemon
The
Automatic Firmware Update link leads you to the page where the automatic update of the Quadro's firmware (software image) can be
configured.
The Next button will move you to the second page of Firmware Update where the image file should be selected manually.
Attention: Pressing the Next button will stop some vital processes on the Quadro, therefore you will need to reboot your device manually even if you
have cancelled the firmware update procedure on the following steps.
The second page of Firmware update has a Browse
button used to browse the image file, and the Specify
Image
text field that will display the selected image
filename.
Pressing Save
will start uploading the image file to the
board and the next page will display results and
verification of the image being burned.
Fig. II-54: Firmware Update page
This page displays non-editable information about the
image validity. The Image Check field will display “invalid”
if the image does not correspond to the hardware version.
The Current Software Version
field shows the old
software version. The New Software Version field shows
the new version of the software image.
This page needs to be confirmed in order to continue
image updating. If you are sure that the image version is
appropriate for your device press Save.
Fig. II-55: Firmware Check page