Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus

QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)

Numerous circumstances may cause a certain application on

Quadro to flag an event.

The Event Settings page lists all possible events on the Quadro

and allows controlling notification (action) when an event takes

place.

Each entry in the events’ table has a checkbox assigned to each

row. By selecting the corresponding checkboxes, operations such

as Edit may be done for one or more events.

Edit opens the Edit Event Settings page to modify the event

action.

Fig. II-47: Event Configuration Settings page

The Edit Event Settings page offers the following input options:

Application displays the application the event refers to. Multiple

is shown here if more than one event has been selected for the

action assignment.

Name displays the name of the event. Multiple is shown here if

more than one event has been selected for the action

assignment.

Description displays additional information about the event.

Multiple is shown here if more than one event has been selected

for the action assignment.

Action offers radio buttons to choose one of the actions to notify

the Quadro administrator when an event(s) takes place. The

following actions can be available:

Fig. II-48: Edit Event Settings page

• Display Notification - A notification link will be displayed on the bottom of all pages and a record is added into the Events table. The

notification is executed as a link “Please Check your pending events!”. The link leads to the System Events page. This action also will take

place if Flash LED or Send Mail has been selected, even if not specifically selected.

• Flash LED - The second LED (yellow) will blink every second and a notification will be displayed on the bottom of all pages. For some events

the LED will start flashing after a delay.

• Send Mail – an e-mail notification about the new event on the Quadro will be sent to the e-mail address specified in the Mail Settings page.

• Send SNMP Trap – SNMP notification will be sent to the traphost(s) listed in the SNMP Trap Settings table (see SNMP Settings).

• Send SMS – SMS notification about the new event on the Quadro will be sent to the mobile phone specified in the SMS Settings page.