Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
20
Show button is used to generate an FXO channels usage diagram
chart over the parameters selected above.
When this button is pressed, FXO Channel Usage Statistics chart
appears. It represents dependency between the time frame and the
number of calls performed during that period. Additionally it may
display the maximum number of calls performed in the selected time
frame.
The Line Status for any shared ISDN Trunks on the Quadro displays
the state of the B1 and B2 channels and the information about the
active calls on them. This page includes a group of static and dynamic
parameters. Static parameters are always displayed. Dynamic
parameters appear only when an event takes place on the channel.
Fig. II-26: FXO Channel Usage Statistics chart
Static Parameters:
• B channel - the state of the channel (enabled or disabled)
• State - the current state of the channel (free, busy or N/A)
Dynamic Parameters:
• Caller Party - this parameter appears when a call is received and
indicates the caller address
• Called Party - this parameter appears when a call is placed and
indicates the destination address
• Call Duration - current call duration (in seconds)
The ISDN Channel Usage Statistics
link is only present for local
ISDN lines (this option is not available for shared ISDN lines) and leads
to the page where diagram chart of ISDN trunks usage can be viewed.
Fig. II-27: Lines Status page
The ISDN Channel Usage Statistics page consists of following
components used to define the chart parameters:
Trunk checkboxes are used to select the ISDN line number(s) over
which the ISDN traffic chart will be built. At least one Trunk checkbox
should be selected, otherwise error message appears.
Time range of statistic table drop down list includes the period (in
days) statistics data that is to be collected and the corresponding
diagram chart that is to be built.
Incoming Calls and Outgoing Calls checkboxes are used to select
whether the ISDN traffic statistics for only incoming or outgoing or for
both type of calls should be displayed in the diagram chart.
Maximum Active Calls checkbox is used to have the number of
maximum active calls displayed in the diagram chart.
At least one of these checkboxes should be selected, otherwise error
message appears.
Fig. II-28: ISDN Channel Usage Statistics page