Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
19
The button Show generates an E1/T1 Channel Usage Statistics
diagram over the selected criteria. The letters M and K used in the
legend of the displayed diagrams show the total number of specified
criteria: K means thousands and M millions.
Fig. II-23: E1/T1 Channel Usage Statistics chart
The Lines Status table of any shared FXO Line on the Quadro
provides information about the Allowed Call Types, the extension
number (attendant or routing client), to whom the Incoming Call is
Routed To and the State of the line (Free or Busy).
The FXO Channel Usage Statistics link is only present for local FXO
lines (this option is not available for shared FXO lines) and leads to the
page where diagram chart of FXO lines usage can be viewed.
Fig. II-24: Line Status - FXO Status page
The FXO Channel Usage Statistics page consists of following components used to define the chart parameters:
Trunk checkboxes are used to select the FXO line number(s) over
which the FXO traffic chart will be built. At least one Trunk checkbox
should be selected, otherwise error message appears.
Time range of statistic table drop down list includes the period (in
days) statistics data that is to be collected and the corresponding
diagram chart that is to be built.
Incoming Calls and Outgoing Calls checkboxes are used to select
whether the FXO traffic statistics for only incoming or outgoing or for
both type of calls should be displayed in the diagram chart.
Maximum Active Calls
checkbox is used to have the number of
maximum active calls displayed in the diagram chart.
At least one of these checkboxes should be selected, otherwise error
message appears.
Fig. II-25: FXO Channel Usage Statistics page