Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus

QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)

The Line Status for E1/T1 Trunk displays the list of available timeslots

(in E1 mode, 30 active timeslots both for CAS and CCS signaling

types; in T1 mode, 24 timeslots for CAS signaling and 23 timeslots for

CCS signaling type) and their settings (Route Incoming Call to,

Allowed Call Type and Timeslot State). When Timeslot is in the call,

information about call direction (incoming or outgoing), Caller Party,

Called Party and Call Duration is displayed.

Fig. II-21: Line Status – Line Status page for E1/T1 trunk

The E1/T1 Channel Usage Statistics page consists of following

components used to define the chart parameters:

Trunk checkboxes are only present when there is more than one

E1/T1 trunks present on the Quadro. These checkboxes are used to

select the E1/T1 trunk number(s) over which the E1/T1 traffic chart will

be built. At least one Trunk checkbox should be selected, otherwise

error message appears.

Time Range of Statistic Table drop down list includes the period (in

days) statistics data that is to be collected and the corresponding

diagram chart that is to be built.

Incoming Calls - number of incoming E1/T1 calls

Outgoing Calls - number of outgoing E1/T1 calls

Maximum Active Calls - number of maximum active E1/T1 calls

At least one of these checkboxes should be selected, otherwise error

message appears.

Fig. II-22: E1/T1 Channel Usage Statistics page