Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Appendix: System Default Values
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
179
Parameter System Default Value
SIP TCP Port – 5060
STUN Parameters:
Primary STUN Server - stun.epygi.com
Primary STUN Port – 3478
Secondary STUN Server – undefined
Secondary STUN Port - undefined
Polling Interval: 1 hour
Keep-alive interval: 120 seconds
NAT IP checking interval: 300 seconds
No entries in NAT Exclusion table.
Line Settings
(for QuadroM8L/12Li)
Onboard Lines Configuration:
CallerID - Standard 2 FSK for all lines
Ringer type: Type A for all lines
Busy Tone and Power Disconnect indications: disabled for all lines
Off-hook caller ID - disabled for all lines
Hot Desking Capability – disabled for all lines
IP Lines Configuration:
Enable PnP for IP lines – enabled,
Enable firmware version control – enabled,
Configure IP phones from – WAN,
Phones Default Template – systemdefault,
IP Phone Templates – no custom templates,
IP Phone Logo – disabled, no custom logos uploaded,
FXS Gateway Management – undefined,
IP Lines 1-32 – enabled,
IP Lines 33-96 – disabled,
1-96 IP Lines attached to 103-198 extensions. All IP lines are in inactive mode.
Disabled IP lines – displayed.
FXS Lines Loopback Settings – Loopback is disabled for all FXS lines, Loopback
timeout is 30.
Line Settings
(for QuadroM26x/26xi)
Onboard Lines Configuration:
CallerID - Standard 2 FSK for all lines
Ringer type: Type A for all lines
Busy Tone and Power Disconnect indications: disabled for all lines
Off-hook caller ID - disabled for all lines
Hot Desking Capability – disabled for all lines
IP Lines Configuration:
Enable PnP for IP lines – enabled,
Enable firmware version control – enabled,
Configure IP phones from – WAN,
Phones Default Template – systemdefault,
IP Phone Templates – no custom templates,
IP Phone Logo – disabled, no custom logos uploaded,
FXS Gateway Management – undefined,
IP Lines 1-16 – enabled,
IP Lines 17-80 – disabled,
1-80 IP Lines attached to 127-206 extensions. All IP lines are in inactive mode.
Disabled IP lines – displayed.
FXS Lines Loopback Settings – Loopback is disabled for all FXS lines, Loopback
timeout is 30.
Line Settings
(for QuadroM32x)
Onboard Lines Configuration:
CallerID - Standard 2 FSK for all lines,
Ringer type: Type A for all lines,
Busy Tone and Power Disconnect indications: disabled for all lines,
Off-hook caller ID - disabled for all lines,
Hot Desking Capability – disabled for all lines,
IP Lines Configuration:
Enable PnP for IP lines – enabled,