Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
17
Static Parameters:
Extension shows the extension number of the selected telephone line.
Display Name shows the corresponding name.
Phone State may have the value On Hook or Off Hook. For IP Line
Status, this field may additionally have Not Configured and Temporary
Offline values.
Number of Active Calls shows the number of calls that are currently
present on the phone.
Dynamic Parameters:
Call State shows the current state of the extension (in voice mail, in
call, waiting, busy, call out, ring in, etc.).
Caller Party appears when a call is received and indicates the caller
extension and the IP address or a phone number, depending on type of
call.
Called Party appears when a call is placed and indicates the
destination extension and the IP address or a phone number,
depending on type of call.
Call Type shows whether the call is Internal or External and whether it
is a PSTN call, PBX call or IP call.
Call Start Time shows the call start date and time.
Call Duration shows the current call duration.
RX Codec shows the codec used to encrypt the incoming packets. TX
Codec shows the codec used to encrypt the outgoing packets. If RX
and TX codecs are the same, only one Codec field will be displayed.
Fig. II-20: Lines Status - Lines Status page upon established call
For IP Line Status, the following dynamical parameters appear on this page:
Username shows the IP phone’s client name registered on the Quadro.
Last Registered shows the date and time, the corresponding IP phone has been last registered on the Quadro.
Expires In shows when the last registration of the IP phone will expire.
Binding IP Address shows the IP address of the IP phone within the Quadro’s LAN network.
The list of supplementary services provides the following additional status information for each telephone line: Enabled or Disabled.
For Incoming and Outgoing Call Blocking, Speed Calling, Hiding Caller Info, Voice Mailbox and Group List services, the number of Entries
will be displayed in the corresponding service table. For Voice Mail Service, the voice mailbox configuration mode is displayed here.
This allows administrator to view the status and to be notified about services running on Quadro for every line. The services are designed as links
that guide the administrator to the corresponding service page of the selected user.