Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
162
Add functional link opens the page Add Host where a list of
aliased can be defined for the certain device in the Quadro’s
LAN. The page contains the following components:
IP Address text fields require the IP address of the device in
the Quadro’s LAN.
Hostname text field requires the hostname of the device in the
Quadro’s LAN.
Alias text fields are used to enter up to 5 alias names by which
the device in the Quadro’s LAN will be resolved.
Fig. II-280: DNS Server Settings – Add Host page
DHCP Settings for the LAN Interface
The DHCP Settings for the LAN Interface page provides the option of enabling a DHCP server and controlling the Quadro user’s LAN settings.
Therefore, Quadro LAN users will automatically be provided with the following settings using the configured parameters:
• IP addresses
• NTP (corresponds to the Quadro’s IP address)
• WINS server
• Nameserver (corresponds to the Quadro’s IP address)
• Domain name
The DHCP Settings for the LAN Interface page offers the
following input options:
Enable DHCP Server checkbox activates the DHCP server on
Quadro. With this checkbox enabled, Quadro will be able to
assign dynamic IP addresses to the devices in its LAN.
Give leases only to hosts listed in the static MAC address
binding table
checkbox enables the DHCP services only for
the devices listed in the table below. With this checkbox
selected, no DHCP services will be provided to the other
devices.
Please Note: When this checkbox is selected, all IP phones
configured to use plug and play or auto configuration services
(see
IP Line Settings) will keep their IP addresses received from
the DHCP server of the Quadro. The IP phones that are
configured manually should be added to the Special Devices
table to keep their IP addressed.
Fig. II-281: DHCP Settings page for LAN interface
IP Address Range defines a range of IP addresses that will be assigned to the Quadro LAN users. The IP range must be at least 6, otherwise the
error message “Address Range too small” will prevent it from being saved. The error message “Address Range too large” will appear if the IP range
is greater than 254.
WINS Server defines a WINS server IP address for the Quadro LAN users.
DHCP Advanced Settings link leads to the page where the advanced options of the Quadro's DHCP server can be configured.
The Special Devices table on this page allows you to set a static IP address binding on the MAC address of the device in the Quadro’s LAN. When
this table is configured, the devices with defined hostnames and MAC addresses will always get the same LAN IP address from the DHCP server.
Otherwise, devices not listed in this table will get dynamic LAN IP addresses. This table is also displayed in the
System Configuration Wizard.
Add functional button opens an Add Host page where a new
static MAC address binding can be defined. The page consists
of the following components:
Hostname text field requires the hostname of the device in the
Quadro’s LAN.
MAC Address text fields require the MAC address of the
device in the Quadro’s LAN.
Static IP Address text fields require a fixed IP address of the
device in the Quadro’s LAN.
Please Note: If you leave this field empty, the device in the
Quadro’s LAN will get the first available IP address from range
defined in the DHCP Settings page (see above).
Fig. II-282: Static MAC address binding – Add Host page
View DHCP Leases leads to the page where the DHCP leased LAN IP addresses are listed.