Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
133
The Call Routing Wizard – Tracing/Debug Options page appears if
the Set Tracing / Debug Options on This Rule checkbox was
previously enabled on Page 1 of the Local Call Routing Wizard. It will
require information about the tracing/debug options.
This page offers result options of the corresponding routing rule
execution when the notification event will be printed in the
Events
page.
• In Case of Successful Call – a notification event is
printed when the successful call was established with the
routing rule.
• In Case of Failover – a notification event is printed when
the call ends up on one of the failover reasons selected on
the Page 2 of the Local Call Routing Wizard.
• In Case if Call Failed to Establish – a notification event
is printed when the call executed with the routing rule
failed.
Fig. II-227: Call Routing Wizard – Tracing/ Debug Options page
The Call Routing Wizard - Class of Services - Edit Entry page is
used to assign the defined class of services to a certain call routing
pattern. To use Class of Service feature for the corresponding routing
rule, it should be enabled from the
Class of Service page.
The Class of Service(CoS) functionality allows to permit or deny the
attempt of extensions to use certain types of call routing rules.
Suppose you want for a certain group of PBX/Conference extensions
to deny the right to make international calls, but allow them to make
local and long distance calls and for another group of PBX/Conference
extensions give a permission to make international calls only.
The classes defined in the
Class of Service page will appear on this
page to assign the corresponding routing rule to a certain class of
service(s).
Please Note: The Class of Service
feature is applicable only
for PBX source type routing rules.
Please Note: The Filter on Source/Modify Caller ID option should be
selected on the first page of the Call Routing Wizard to have a
possibility to select the source caller type as a PBX.
Each routing rule can be attached to a several class of service(s).
Fig. II-228: Call Routing Wizard – Class of Services – Edit Entry page
Please Note: Established patterns based on the Emergency Codes and PSTN Access Codes Settings in the
System Configuration Wizard will be
marked in bold and will be placed in the first position in the Call Routing Table. Additionally, they cannot be modified and deleted from the Call
Routing Table.
The Duplicate functional button is used to create a routing pattern with the settings of an exiting one. This is to avoid configuring a new routing entry
completely by duplicating an existing entry with different settings. To use the Duplicate button only one record may be selected, otherwise the error
message “One row should be selected” will appear. The Duplicate button opens the Call Routing Wizard where all fields except the Pattern field
are already filled in. A Pattern for the new route will be required anyway.
The Move Up and Move Down buttons are used to move call routing patterns one level up or down within the Call Routing table. The sequence of
the routing patterns is important when making routing calls because the Call Routing table is parsed from the top down and routing will take place
according to the first pattern that matches the dialed number. The Move To button is used to move the selected entry to a different position in the
Call Routing Table. This will increase or decrease the selected pattern’s priority. Pressing the button will open the page where a row number should
be specified together with the position the selected entry is to be placed (before or after the defined row).
Local AAA Table
The Local AAA Table page allows you to manage local authentication and the authorization database. Callers dialing the routes which have an AAA
(Authentication, Authorization, and Accounting) option enabled, will pass the authorization on the Local AAA Table by using a phone number or
username/password, depending on the corresponding entry configuration on this page.