Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
13
The System Security Diagnostics page allows running the security audit and getting the security reports. The Start Security Audit functional
button is used for running the security audit. The QuadroM Security Audit is a security reporting system, which generates the warnings regarding the
QuadroM's weaknesses relative to the selected Security Level. The warnings may vary depending on the selected global Security Level. The
Security Audit will detect the security related configuration issues in Firewall, IDS, IP Line passwords, Call Routing and extension settings.
The output of Security Audit may look as follows:
Start security audit...
Checking...
Firewall ... done
IP Lines ... done
Call Routing ... done
Extensions ... done
Users ... done
Settings do not correspond to selected security
level.
You can view the complete report by clicking the
'Show the latest security report' link below.
Fig. II-13: QuadroM System Security Diagnostics page
The Show the latest security report link allows to display the last security audit report. This page also contains the following useful links to adjust
the system security:
• User Rights Management
• IP Line Settings
• Firewall/NAT
The SIP IDS Settings
page includes the following
components:
Enable SIP IDS checkbox selection allows to prevent the SIP
attacks.
The Add the IP address into the Blocked IP list in Firewall
checkbox allows to block SIP attacker’s IP address. SIP
attacker’s IP address will be blocked by QuadroM Firewall and
will be added on the Firewall Blocked IP List table.
The Discard SIP messages from IP address for checkbox
allows to discard the accumulated SIP messages from the
QuadroM SIP cash after defined timeout (default timeout value
of “Discard SIP messages from IP address for” service is 32
seconds).
Fig. II-14: QuadroM SIP IDS Settings page