Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
120
The Connection Type manipulation radio button group allows
you to choose the connection type for the selected trunk(s):
• PTP (Point to Point)
In case of connection to the CO (User interface type is
selected on Quadro) choose this option if only Quadro is
connected to the ISDN trunk from CO (no other ISDN
devices are connected to the particular ISDN trunk from
CO besides the Quadro).
In case of connection to the PBX (Network interface type
is selected on Quadro) choose this option if only the PBX is
connected to the ISDN trunk from the Quadro (no other
ISDN devices are connected to the particular ISDN trunk
from the Quadro).
In both cases, with this selection, Quadro sets the TEI to
manually mode assi
gning the default value of 0. If needed,
that value can be changed later in the Advanced Settings
page of ISDN Wizard.
Fig. II-207: ISDN Wizard – ISDN Settings
• PTMP (Point to Multi Point)
In case of connection to the CO (User interface type is selected on the Quadro) choose this option if there can be other devices connected to
the same ISDN trunk from CO except the Quadro.
In case of connection to PBX (Network interface type is selected on the Quadro) choose this option if there can be other devices connected to
the same ISDN trunk from Quadro except for the PBX.
In both cases, with this selection Quadro sets the TEI to automatic mode.
Please Note: Consult with your CO operator or network administrator before configuring the ISDN connection type.
The ISDN Wizard - Page 2 content is dependent on the connection type selected on the previous page of ISDN Wizard:
The next page is ISDN Wizard – MSN Settings page which is
used to turn on the MSN configuration. It is recommended to
enable the MSN when there are multiple ISDN devices
connected to the same ISDN bus. If the MSN is enabled on this
page, the next page will require the MSN table configuration.
Fig. II-208: ISDN Wizard – ISDN PRMP Settings
For MSN service enabled, the Routing Settings page is used to assign MSN numbers to the certain destinations on the Quadro. The MSN number
can be assigned to the Quadro’s extensions, to the Auto Attendant, or to the routing agent. The destination selected from this page will ring upon
incoming call to the corresponding MSN number comes in.