Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
118
• Receive Not Ready - controlling packets in case of inability to accept calls by destination.
• SABME - packets upon connection establishment.
• Disconnected Mode - packets when connection is being disconnected.
• Disconnect - packets upon connection termination.
• Unnumbered Acknowledgement - packets upon accepting connection establishment/termination.
• Framer - packets as a report of an error condition.
• TEI -
packets containing TEI (Terminal Endpoint Identifier) to
initiate subscription of the device in the network.
• Unnumbered Information Frame - broadcast signaling
packets received for call initiation and termination.
• Exchange Identification - received packets containing
connection management settings.
ISDN PRI Layer 2 Errors statistics:
• Incorrect Length - packets with incorrect length.
• Bad Supervisory Frame - packets with incorrect
supervisory header.
• Bad Unnumbered Information Frame - packets with
incorrect unnumbered information frame header.
• Bad Frame Type - packets with bad frame type.
• Bad Unnumbered Frame - packets incorrect unnumbered
acknowledgement frame header.
• Bad TEI Value - packets with bad TEI (Terminal Endpoint
Identifier) value.
ISDN PRI Layer 3 statistics shows the same information as for
CAS signaling.
No E1/T1 trunk statistics is displayed in this page at first, but page
is getting automatically refreshed every 10 minutes. Statistics
collected since that time and the last resetting of the counter will
be displayed here.
The Blocked Timeslots text field lists the timeslots blocked by
the carrier. The field is present for E1/T1 CAS R2 signaling type
only.
Current System Time displays the actual time on the Quadro
and the Last Time Cleared displays the exact date and time
when the E1/T1 Stats has been manually cleared last time.
System Uptime displays the period Quadro is on since last
reboot.
To reset the statistics counters press the Clear button.
Fig. II-203: E1/T1 Trunk Stats page
Incoming Interdigit Service
The Incoming Interdigit Service is used to configure E1/T1 dial
plan for the incoming calls from CO/PBX to the Quadro. This
service allows you to speed up the call establishment procedure
by detecting the prefix. The calls will be speed up by the timeout
defined in the Incoming Digits Timeout text field.
When the system detects incoming dialed number starting with
any of the prefixes listed in the Incoming Interdigit Service
table, it will wait for the rest of the digits, as specified for the
corresponding prefix in the Incoming DNIS Size text field (see
below). Once all digits are received, the system will route the call
to the destination.
The Incoming Interdigit Service
page lists a table with existing
E1/T1 dial plan entries and allows you to manage them.
By default, the table on the Incoming Interdigit Service page
lists the locale specific (selected from the
System Configuration
Wizard) E1/T1 dial plan settings. For some countries, this table
may however be empty.
Fig. II-204: Incoming Interdigit Service page