Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
111
Voice Establishment Procedure manipulation radio buttons group is used to select a method of voice establishment on the trunk:
• On call acceptance – with this selection, voice will be established after call is being accepted.
• On channel selection - with this selection, call will be accepted during channel selection. This selection is not allowed for R2 signaling.
• On call ringing - with this selection, voice will be established after call is being ringing. Selection enables Generate Progress Tone
checkbox which is used to enable the progress tone generation upon voice establishment.
CAS Signaling Wizard - Page 2 appears if the Signaling Type on
the previous page is set to any of the E&M types or to R2 DTMF.
The page provides the possibility of enabling the DID Service on
the timeslot(s) and contains the following component:
The Enable DID Service checkbox is used to enable/disable DID
(Direct Inward Dialing) service for the selected timeslot(s).
Fig. II-194: CAS Signaling Wizard – Page 2
CAS Signaling Wizard – Page 3 allows to set the destination for
incoming calls to be routed to and to enable Cut Through and
Automat Ringing Down services for signaling different from R2
(all types).
Route Incoming Call to drop down appears when Both incoming
and outgoing calls or Incoming calls only is selected from the
Allowed Call Type list and allows selecting the destination where
incoming calls should be routed. The list contains all extensions of
the Quadro, Attendant and Routing agent. The routing agent gives
two kinds of call routing possibilities in user mode and one in
network mode. Choosing the Routing selection (available in User
mode only) will request the caller to pass the authentication (if
enabled) and will invite the caller to dial the destination number to
connect the user within the Quadro Network. Choosing the
Routing with inbound destination number
selection will
automatically use the initially dialed number to connect the
destination without any additional dialing.
When DID service is enabled (in User mode only), incoming calls
can be only routed to the Routing agent with simple Routing and
Routing with inbound destination number
call routing
possibilities.
Fig. II-195: CAS Signaling Wizard – Page 3
Attention: When Quadro acts in the Network mode with the Attendant as a destination to route the incoming calls, digit forwarding should be
disabled on the PBX side. Otherwise, incoming digits may be mistaken as special calling codes on the Quadro’s Attendant.
Cut Through checkbox is available when signaling selected from the Signaling Type drop down list on the CAS Signaling Wizard – Page 2 is
different from R2 (all types) and is used to reconnect the call (terminated by some reason, e.g. user error, network problems, etc.) by going on-hook
and off-hook again even if the call partner is off-hook and not involved in the call.
Automat Ringing Down checkbox is available when signaling selected from the Signaling Type drop down list on the CAS Signaling Wizard –
Page 2 is different from R2 (all types) and allows an E1/T1 device connected to the Quadro to establish a hot-line call (automatic call without any
digits dialed).
Pass Through Pound Sign (#) checkbox is only available when signaling selected from the Signaling Type drop down list on the CAS Signaling
Wizard – Page 2 is different from E&M FGD or R2 (except for R2-DTMF). When this checkbox is selected, the pound sign (#) detected in the dialed
number will be passed through and will be considered as a part of the dialed number. When this checkbox is not selected, the detected pound sign
(#) will be considered as a call acceleration digit.