Installation guide

QuadroM32x/8L/26x/12Li/26xi Manual II: Administrator's Guide Administrator’s Menus
QuadroM32x/8L/26x/12Li/26xi; (SW Version 5.3.x)
106
IP Phones Logo
The IP Phones Logo page is used to upload a custom logo for
the IP Phones. This page contains only those IP phones for which
Quadro supports the custom logo upload. The uploaded custom
logo will be visible on the display of the IP phone.
The Enable checkbox is used to enable the custom logo for the
selected IP phone model(s).
The Browse button opens the file-chooser to select the custom
logo file.
Fig. II-183: IP Phones Logo
FXS Gateway Management
The Quadro FXS Gateway is an analogue Gateway that allows
connecting analogue phones to a VoIP network. The device can
be used with QuadroM IP PBXs to emulate additional FXS ports.
Both QuadroM IP PBX and the FXS Gateway should be located
in the same network. QuadroM IP PB
X is connected to the
Quadro FXS gateway through its MAC address.
The FXS Gateway Management page is used to define Quadro
FXS Gateway devices in your network that can serve as FXS
expansion modules for your QuadroM IP PBX. Additional FXS
lines provided by the FXS Gateway can be connected to the IP
lines on the QuadroM IP PBX.
Fig. II-184: FXS Gateway Management page
Add functional button opens FXS Gateway Management
Wizard where new FXS Gateway should be defined.
The FXS Gateway Configuration Wizard - FXS Gateway
Model page contains following components:
• The FXS Gateway Model drop down list is used to
select the FXS Gateway model to be used as an FXS
expansion device.
• The MAC Address text fields require the MAC Address
of the FXS Gateway. Based on the selected FXS
Gateway model and the inserted MAC Address, the
FXS Gateway can be automatically configured by
simple reset/reboot.
• The Description text field requires the description of
the FXS Gateway to be configured.
Fig. II-185: FXS Gateway Management Wizard – page 1