Installation guide

QuadroCS Manual II: Administrator's Guide Administrator's Menus
QuadroCS (SW Version 3.1.x) 8
The System Configuration page contains the host name,
IP address and Subnet Mask information about the Quadro
LAN interface. These settings make Quadro available to
the internal network.
The System Configuration page offers the following input
options:
Host Name requires a host name for the Quadro device.
IP Address requires the Quadro host address for the LAN
interface.
Subnet Mask requires the Quadro hosts’ Subnet Mask.
Fig.0-5: System Configuration Wizard – System Configuration page
The Regional Settings and Preferences are used to select
settings specific to the location of the Quadro. This is
important for the functionality of the voice subsystem.
The Regional Settings and Preferences page has two drop
down lists to select the Location (country) and a
corresponding Timezone. This page also has a manipulation
radio button group to choose:
• System Language – selection is available only when
the custom Language Pack has been uploaded and it is
used to enable custom language for system voice
messages or returning back to the default language
English.
• GUI Theme - selection used to select the GUI theme
style of the web based configuration pages.
Fig. 1-5 System Configuration Wizard – Regional Settings page
Internet Configuration Wizard
The Internet Configuration Wizard allows the administrator to configure the WAN interface settings and to adjust Quadro’s connectivity with an
external network. The Internet Configuration Wizard MUST be run for Quadro to be connected to the Internet.
All the settings of the Internet Configuration Wizard are
described in the chapters below except those for the IP
settings, which will be described in this chapter.
Please Note: It is strongly recommended not to change the
factory default settings if their meanings are not fully clear
to an administrator.
Fig. II-6: Internet Configuration Wizard - Start page