Installation guide

QuadroCS Manual II: Administrator's Guide Appendix: System Default Values
QuadroCS (SW Version 3.1.x) 51
Issue System Default Value
Conference Settings – Participants
No participants in the table.
New Participant Allowed to Join – enabled,
Max New Participant Count – 10,
New Participant Type – speaker,
New Participant Confirmation Type – none,
New Participant Can Activate The Conference – enabled,
New Participant Indication – enabled,
Handset Added Participant Configuration:
Participant Type – speaker,
Confirmation Type – none,
Participant Indication – enabled,
Allowed Duplicated Participants – enabled.
Conference Settings – Schedule
No entries in the table.
Allow Participants to Join before Conference Activation – disabled,
Send Mail before Conference Activation – disabled,
Send Mail on Behalf of – undefined.
Conference Settings – Reservation
No entries in the table.
Conference Settings – AGC
Disabled.
Attendant 00 Settings – General
Description – Attendant,
Percentage of System Memory - 2%.
Attendant 00 Settings – Attendant
Scenario
Scenario – default,
Attendant Welcome Message – default,
ZeroOut Service – disabled.
Attendant 00 Settings – SIP
SIP User Name – automatically generated,
SIP Registration server - sip.epygi.com,
SIP server port – 5060,
SIP Registration – enabled.
Attendant 00 Settings – SIP Advanced Same as for a default conference.
Attendant 00 Settings – Codecs
Codecs - G711u (preferred), G711a, G726/16, G726/24, G726/32, G726/40, G729a, G723,
iLBC
Out of Band DTMF Transport – enabled.
SIP Settings
UDP and TCP Port – 5060,
Session Timer – disabled,
DNS Server for SIP – default,
SIP timers – RFC 3261.
RTP Settings
Properties for all Codecs except G723 and iLBC :
Packetization -20ms
Silence Suppression -yes
G723 and iLBC properties:
Packetization - 30ms
Silence Suppression – yes
G276 Standard - ITU-T specification
RTP/RTCP port range - 6000-6059
Telephone Event Draft Support - enabled
RTCP Support - disabled
NAT Traversal Settings
NAT Traversal for SIP – Automatic
SIP and RTP Parameters - Use STUN
SIP TCP Port – 5060
STUN Parameters:
Primary STUN Server - stun.epygi.com,
Primary STUN Port – 3478,
Secondary STUN Server – undefined,
Secondary STUN Port – undefined,
Polling Interval: 1 hour,
Keep-alive interval: 120 seconds,
NAT IP checking interval: 300 seconds,
No entries in NAT Exclusion table.
Statistics Enabled, 100 entries for all type of calls.
Call Routing No entries.