Installation guide

QuadroCS Manual II: Administrator's Guide Administrator's Menus
QuadroCS (SW Version 3.1.x) 44
Restriction radio buttons:
• Selecting Any blocks or allows all host IP addresses. This selection is not present for the Management Access, Blocked and Allowed IP List
rules.
• Selecting Single IP will require the IP address of the allowed or blocked host.
• Selecting IP/Mask will require the subnet to be allowed or blocked, specified by an IP address and the Maskbits. Maskbit examples:
255.0.0.0= /8,
255.255.0.0 = /16,
255.255.255.0 = /24,
255.255.255.255= /32
• Group indicates the user defined groups that include IP addresses that ought to be allowed or blocked.
To Add a Filtering Rule
1. Select the Filter link (Incoming Traffic/Port Forwarding, Outgoing Traffic, Management Access, SIP Access, Blocked IP List or Allowed IP List)
to add a rule for it. The corresponding Filter table will appear in the same window.
2. Click Add on the Filtering Rules page. A page where a new rule may be added will appear in the browser window. The page will be named
corresponding to the selected filter.
3. Select a service name from the Service list to configure a rule for it. If the list has a default value, leave it as is.
4. Select an action from the Action list that is used in the rule. If the list has a default value, leave it as is.
5. Enter the IP address in the Forward to IP field if an Incoming Traffic Rule is to be added.
6. Choose the restriction type by selecting Any, SingleIP or IP/Mask and enter the required information in the text fields or select a group.
7. To add a rule with these parameters press Save.
To Delete Filtering Rules
1. Select the Filter link to delete a rule from its table. The appropriate Filter table will appear in the same window.
2. Check one or more checkboxes of the corresponding rules that ought to be deleted from the rules table. Press Select all if all rules ought to be
deleted.
3. Press the Delete button on the Filtering Rules page.
4. Confirm the deletion with Yes, or cancel it with No.
Service Pool
The Service Pool table is a list of all created services and their
parameters. It is used to add new services with the appropriate
settings (protocol type and port range). New services can be
used to add a restriction or permission by defining a new
filtering rule:
Add opens the Add New Service page where new services
may be added.
Edit opens the Edit Service page where the service
parameters (except for the service name) can be modified. This
page includes the same components as the Add New Service
page. To operate with Edit only one record may be selected,
otherwise an error will occur: “One row must be selected”.
Fig. II-74: Service Pool page
The Add page is used to add new services and includes the
following text fields and buttons:
Service Name requires a name for the service that ought to be
added.
Protocol includes a list of possible protocols to be selected.
Port Range requires a port range for the defined service.
Fig. II-75: Service Pool - Page to add a new Service
To Add a new Service
1. Select the Manage User Defined Services link on the Filtering Rules page.
2. Click on the Add button on the Service Pool Configuration page. A page where a new service may be added will appear in the browser
window.