Installation guide

QuadroCS Manual II: Administrator's Guide Administrator's Menus
QuadroCS (SW Version 3.1.x) 20
4. Press the Traceroute button to process the router triggering.
Diagnostics
The System Diagnostic page gives a possibility of running Network and WAN protocol diagnostics to verify QuadroCS’s connectivity and to
download all system logs for possible problems recovery.
The Start Detecting WAN Protocol button is used to initiate WAN diagnostics that will detect the WAN IP configurations: static or through DHCP
and PPP servers. For static WAN IP configuration, gateway availability is checked. When acting as a client, DHCP and PPP servers' accessibilities
are being verified.
The Start Network Diagnostics button is used to initiate network
diagnostics, i.e., to check the WAN link and IP configuration, to
verify gateway, DNS primary and secondary (if configured) servers'
accessibilities.
The field below will display the diagnostics results and the
connectivity conditions. The system should be reconfigured if
problems occur during the diagnostics.
The Download system logs button is used to download all logs to
the local PC as a *.tar archive file. These logs can then be used by
the Epygi Technical Support Office to determine the problem that
has occurred on your Quadro.
The Reboot this Device button is used to reboot the Quadro.
Please note that the session with the Quadro will be closed, i.e.,
the Quadro GUI should be newly opened and a new login will be
required afterwards.
Fig. II-30: System Diagnostic page
Automatic Provisioning
Automatic Provisioning provides the possibility to automatically
configure the WAN network settings of Quadro. This is very useful
when the administrator is not actually aware about the Quadro’s
network settings. Automatic Provisioning automatically detects
the matching network configuration settings, applies them on the
Quadro, thus connecting the device to the internet through the
available ISP connection.
Please Note: Automatic Provisioning can only be run from the
LAN side of the Quadro, i.e. from the PC connected to the
Quadro’s LAN.
Automatic Provisioning automatically detects and configures the
following settings on the Quadro:
• WAN interface type (PPPoE or Ethernet)
• WAN IP settings
• PPP settings
• ISP settings
• DHCP settings
• DNS settings
• NAT Traversal settings
Fig. II-31: Auto Provisioning page
Upload Language Pack
Upload Language Pack page allows you to upload a custom
language for GUI and voice prompts of the QuadroCS. The
language of system voice prompts can be switched to the custom
Language Pack language from the GUI setting page in the
System
Configuration Wizard
. The language of GUI session can be
changed to the custom Language Pack language from the radio
buttons on the login page.
Uploading a Language Pack will cause the loss of the following
data:
• All internally stored voice mail
• DHCP leases
• Call statistics
• Pending events
• Transfer statistics
Please Note: Only one custom Language Pack can be uploaded
at the time. Uploading a Language Pack will remove the existing
Fig. II-32: Upload Language Pack page