Installation guide

QuadroCS Manual II: Administrator's Guide Administrator's Menus
QuadroCS (SW Version 3.1.x) 18
Send Test Mail is used to initiate a test e-mail transmission. This button will be enabled if correct values have been submitted and saved on this
page.
To configure the System Mail
1. Enable the system mail sending by the Enable checkbox selection.
2. Update or set the SMTP host in the SMTP Host text field.
3. Update or set the e-mail sender address in the Mail Sender Address text field.
4. Update or set the e-mail address in the Mail Recipient Address text field.
5. Enable SMTP Authentication if it is required on the server.
6. Insert into the corresponding text fields an authentication User Name and User Password defined by your SMTP server.
7. Press the Save button to submit these settings.
8. Use the Send Test Mail button to send a test e-mail with the configured settings.
Firmware Update
This window allows updating the software of QuadroCS by installing new firmware (image). Users registered at Epygi will receive a notice when new
firmware is available and will be able to download it from the Epygi Technical Support WEB page.
Updating new firmware requires a working power supply. QuadroCS is provided with a battery (accumulator). If the battery is low or simply absent
the “There is no battery or voltage is low” warning is displayed.
Please Note: Installing new firmware will take about 15
minutes. During this time, Quadro, telephony and Internet
access will be disabled.
The firmware update will cause the loss of the following data:
• All internally stored recordings and custom voice
messages
• DHCP leases
• Call statistics
• Pending events
• User specific GUI states
The following main processes will be stopped during the
firmware update and will be restarted after the installation is
completed:
• Voice Software
• Network Time Protocol Daemon
• Network Interface Statistic Daemon
• Dynamic DNS Daemon
Please Note: If you consider the
Statistics entries in the
displayed tables to be important, it is recommended to
download them from the corresponding page prior to starting
the Firmware Update.
Next will move you to the second page of Firmware Update
where the image file should be selected.
Fig. II-25: Firmware Update page 1
The second page of Firmware update consists of the Browse
button used to browse the image file, and the Specify Image
text field that will display the selected image filename.
Pressing Save will start uploading the image file to the board.
The next page will be displayed, showing the result of a
verification of the image being burned.
Fig. II-26 Firmware Update page 2