Installation guide

QuadroCS Manual II: Administrator's Guide Administrator's Menus
QuadroCS (SW Version 3.1.x) 16
Numerous circumstances may cause a certain application on
QuadroCS to flag an event.
The Event Settings page lists all possible events on the
QuadroCS and allows controlling notification (action) when an
event takes place.
Each entry in the events’ table has a checkbox assigned to each
row. By selecting the corresponding checkboxes, operations
such as Edit may be done for one or more events.
Edit opens the Edit Event Settings page to modify the event
action.
• Display Notification - A notification link will be displayed
on the bottom of all pages and a record is added into the
Events table. The notification is executed as a link “Please
Check you pending events!”. The link leads to the System
Events page. This action also will take place if Flash LED
or Send Mail has been selected, even if not specifically
selected.
• Flash LED - The second LED (yellow) will blink every
second and a notification will be displayed on the bottom of
all pages. For some events the LED will start flashing after
a delay.
• Send Mail – A notification e-mail about the new event
description in the email will be sent to the e-mail address
specified in the
Mail Settings page.
Fig. II-20: Event Configuration Settings page
Actions that are not allowed for the selected event (like mail notification if the PPP link is down or the mail server has been configured improperly)
are hidden. For multiple events editing, actions that are not appropriate for least one of the selected events will also be hidden.
If QuadroCS cannot receive an IP address from the DHCP or PPP servers, or cannot register an extension on the SIP or Routing servers, or cannot
reach an NTP server, it raises only one event for the entire period the action has failed, but will continue to try. When the required action is
successful Quadro raises an appropriate message.
The Edit Event Settings page offers the following input
options:
Application displays the application the event refers to.
Multiple is shown here if more than one event has been
selected for the action assignment.
Name displays the name of the event. Multiple is shown here
if more than one event has been selected for the action
assignment.
Description displays additional information about the event.
Multiple is shown here if more than one event has been
selected for the action assignment.
Action offers radio buttons to choose one of the actions to
notify the administrator of QuadroCS when an event(s) takes
place.
Fig. II-21: Edit Event Settings page
To Assign an Action to the Event
1. Select the checkbox of one or more events to assign an action to them.
2. Press the Edit button. The Edit Event Settings page appears.
3. Select an action type from the Action radio buttons to notify the administrator about the event.
4. Press the Save button to submit the changes or use Back to abort the selected action.