Installation guide

QuadroCS Manual II: Administrator's Guide Administrator's Menus
QuadroCS (SW Version 3.1.x) 14
Configuration Management
The Configuration Management page assists the administrator with managing the system configuration settings and voice data. For example, the
administrator is able to backup and download the settings to a PC and then upload and restore them back to the QuadroCS. Additionally, this page
provides the possibility of restoring the factory default configuration settings.
The Backup & Download all config & voice data link
generates a backup file with all configuration settings and user
uploaded greeting messages. It opens a file chooser window for
immediate download to the users PC.
The Upload & Restore all config & voice data link opens a
page that has a Browse button, (which opens a file chooser to
select a backed-up file) and a Configuration to Upload field
requiring the file path to upload and to restore it immediately.
Pressing Save will restore the selected backup file, and delete
all current user defined greetings and replace configuration
settings.
Fig. II-17: Configuration Management. page
The Use Default functional button resets all configuration settings and restores the board’s factory default configuration. By restoring the default
configuration you will replace your current configuration, lose all voice mails and reboot the device. You will not be automatically redirected to the
GUI start page. After the successful reboot you will need to enter into the management page and login again to access the Quadro’s configuration. A
warning message will ask you to confirm your selection before restoring the default configuration.
Please Note: Unlike the factory default settings restore procedure initialized from the Reset button on the QuadroCS board, this link will keep the
following data:
• Call Statistics
• Transfer Statistics
• System Events
• Device Registration state
Events
The Events page has two tables. All system events that have occurred will be displayed in one table and event settings will be displayed in the
other.
The System Events page may be accessed through the
Events link from the main menu. It lists information about
system events that have occurred on QuadroCS. When a new
event takes place, a record is added to the System Event table.
For failure events (priority 2 and 3, see below), the warning
“Please check your pending events!” will appear at the bottom of
all management pages.
The system events and the warning message are visible only for
the administrator. The warning link, (which leads directly to the
System Events page) will disappear from the management
pages if the administrator has marked all new events as “read”.
Fig. II-18: Event warning on the main menu page