Installation guide

Reviewed QUIG by Thomas/Isolde Step 2.2: Basic Configuration
Step 2.4: Firewall Configuration
By default, Firewall configuration on the QuadroCS has medium security, which denies any
incoming traffic from the WAN except for voice traffic.
Disabling the firewall is only required to access the Quadro’s management when the
Quadro is connected behind a router. To disable the firewall, open Firewall Configuration
from the Internet Uplink menu. Disable the firewall by deselecting the corresponding
checkbox and save changes.
Fig. I-22: Firewall Configuration page
The Internet connection is properly configured now and you can start generating the first
conference. If this conference will be registered on a SIP server, you have to do that first,
as you will need the SIP Registration information to generate a conference on the
QuadroCS.
As a default there is one conference that is pre-configured on the QuadroCS and the Epygi
SIP server to register automatically.
If you want to use the Epygi SIP Server to register your conference, you have to register at
Epygi Technical Support first (see next step below) to get a login to the Epygi SIP server.
Then the conference may be registered (see step 4) and finally can be set up on the
QuadroCS (see step 5).
If you do not require registration of your conference, skip to
Step 5: Configuring a Confer-
ence on QuadroCS.
QuadroCS (SW Version 3.1.x) 24