Installation guide

Reviewed QUIG by Thomas/Isolde Step 2.2: Basic Configuration

This information will be needed to be inserted in the Internet Configuration Wizard.

rface Protocol and enter the WAN Interface Bandwidth to as-

Uplink Configuration

Select the desired WAN Inte

sure the quality of IP calls.

Fig. I-16: Uplink Configuration

If the available bandwidth is used to the point where the quality of an additional IP call

ould suffer, then new IP calls are rejected.

vice in the United States, typical

e entered here needs to be smaller that the value specified for Up-

tream Bandwidth.

PPPoE (Point to Point over Ethernet) and Ethernet. Use Ethernet for DHCP or static

ge. If PPPoE is the

elected WAN Interface Protocol, the next page will be PPP Settings

The bandwidth provided by your ISP must be specified for both Upstream and Down-

stream fields. The default entry in both fields is 10000, the maximum bandwidth of the 10

MB uplink module. For basic DSL and cable modem ser

values are 300 for Upstream and 1500 for Downstream.

The Min Data Rate text field is used to specify the amount of bandwidth reserved for data

applications. The valu

Specify the WAN Interface Protocol by choosing between available WAN interface proto-

cols:

For Ethernet, clicking Next will display the WAN IP Configuration pa

QuadroCS (SW Version 3.1.x) 19