Installation guide

QuadroCS Manual III: Moderator's Guide Moderator's Menus
QuadroCS (SW Version 3.1.x) 17
New Participants Configuration
This page is used to configure settings of participants independently dialed in to the conference. Once the new participant connects the conference,
he will automatically appear in the
Conference Progress table and remain there unless disconnected from the conference.
Please Note: The settings on this page are displayed in a read-only mode for the users authenticated as participants.
The page consists of the following components:
Selecting the New Participant Allowed to Join checkbox will allow new users to connect the conference by simply dialing in (no previous
registration in
Participants table is needed). If this checkbox is selected, the following settings should be provided:
Max New Participant Count text field requires the
maximum number of new users allowed to connect to the
conference. Leave this field empty to allow unlimited number
of new users connecting the conference.
New Participant Type drop down list is used to select the
state (speaker or listener only) of the new participants
connected to the conference.
New Participant Confirmation Type drop down list is used
to select whether the conference is password protected for
the new users or not.
Selecting the New Participant Can Activate Conference
checkbox will allow the new users to activate the
conference.
Selecting the New Participant Indication checkbox will
enable a beep indication during the active conference when
a new user joins or leaves the conference.
Fig. II-19: New Participants Configuration Page
Handset Added Participants Configuration
This page is used to configure the settings of participants dialed out from the handset by the moderator during the active conference. Once the
handset added participant connects the conference, he will automatically appear in the
Conference Progress table and remain there unless the
conference is terminated. This will allow the handset dialed participant to hang up and dial in to the corresponding conference again while it is active.
Please Note: The settings on this page are displayed in a read-only mode for the users authenticated as participants.
The page consists of the following components:
Participant Type drop down list is used to select the state
(speaker or listener only) of the handset added participants
connected to the conference.
Confirmation Type drop down list is used to select whether
the conference is password protected for the handset added
users or not. When Star (*) selection is chosen, the handset
added user should accept the conference invitation by
pressing the * button.
Selecting the Participant Indication checkbox will enable a
beep indication during the active conference when a
handset added user joins or leaves the conference.
The Allow Duplicated Participation checkbox selection
allows several instances of callers with the same handset
added number (caller address) to join the corresponding
conference at the same time. This option may be used to
allow users from the same network (with the same caller
address), like E1/T1 network, to reach the conference.
Fig. II-20: New Participants Configuration Page