Troubleshooting guide

Epygi Technologies Hidden Pages for Quadro Advanced Configuration
1 Introduction
Along with the basic web management pages available for the administrator, the Quadro IP-PBXs
contain a number of hidden pages (CGIs) that allow for advanced configuration of the
system. The default system settings will work for most applications but they can be changed if
required. Some hidden pages also provide access to troubleshooting tools to collect additional
information.
This document describes the frequently used hidden pages available on Quadro systems. It is
intended to help administrators identify and resolve issues that cannot be resolved through the
typical installation manuals. The options and parameters that are most commonly used will be
explained. The screenshots in this document display the default values of hidden settings.
Please Note: The hidden pages contain low-level system settings and are mainly intended for
Epygi’s technical support engineers and advanced distributors for fine-tuning the system in some
specific configuration scenarios. Wrong or inappropriate configuration of these settings may result
in undesired system behavior. It is strongly recommended not to modify the default settings if
their meanings are not fully clear.
2 The List of the Hidden Pages
Table 1 lists the frequently used hidden pages. More detailed descriptions of these pages are
given in the sections below.
Table 1
CGI Description
1. advanced.cgi
Allows switching off the software watchdog and changing
the default http/https server ports.
2. codecsconfig.cgi Allows configuring voice codec settings.
3. callcapture.cgi Allows making call captures.
4. extmanagement.cgi
Allows configuring certain advanced settings for
extensions and attendants.
5. fxocfg.cgi
Allows adjusting FXO configurations.
6.
fxoconfig.cg
i Allows configuring FXO settings.
7. fxodisconnect.cgi
Allows selecting one of the five basic scenarios for call
disconnection.
8.
generalconfig.cgi
Allows configuring the system general settings.
9.
lantable.cgi
Allows packet traffic prioritization based on IP address.
10.
linesconfig.cgi
Allows configuring FXS lines.
11. netcapture.cgi
Allows making packet captures from a specified network
interface.
12.
trunkecho.cgi
Allows configuring echo settings of ISDN, E1/T1 trunks.
13. tos.cgi
Allows specifying the value for the Type of Service
setting (ToS) for SIP and RTP packets.
14. loadlogo.cgi
Allows to upload/restore company details: logo, running
logo, icon, link.
PAGE 4 17-Feb-15