Troubleshooting guide

Epygi Technologies Hidden Pages for Quadro Advanced Configuration
3.17 kseswitch.cgi
On the Quadro6L/4L the kseswitch.cgi page allows switching between KSE Mode and PBX
Mode (see Figure 25).
Figure 25 KSE Switch page
KSE Mode – is a Key System Emulation mode. When your Quadro is in KSE Mode (first radio
button is selected), SLA lines are configured by default. This means that each FXO line attaches to
one SLA correspondingly and by default configuration files for IP Phones are generated with SLA
Watching (see Figure 26).
Figure 26 Key System Emulation page
PBX Mode – is a Regular PBX working mode. When your Quadro is in PBX Mode (second
radio button is selected), SLA lines aren’t configured by default, but can be set up manually, if
needed. This means that by default no FXO line is attached to SLA and by default configuration
files for IP Phones are generated without SLA Watching.
Making a selection
If your Quadro is in one of these modes and you want to change it, just select the one you want
and press the save button, you will be asked to confirm, also you will be informed that the
Quadro is going to be rebooted and all your configuration changes will be lost, after pressing the
Yes button, all configurations will be resetted and Quadro will be rebooted.
PAGE 28 17-Feb-15