User`s guide

QuadroM 32x/8L/26x/12Li/26xi Manual III: Extension User's Guide Quadro’s Feature Codes
Call Park
Dial

to park a call (system will play the SIP username of the first available extension configured for the call parking). Go
to the remote location and call the extension that initiated the call park to pick up the parked call. If enabled, the system will ask for
the password authentication. If successfully entered, the parked call will be resumed.
To use the Call Park feature, at least one Call Park extension should be created on the Quadro.
Attention: The Call Parking is valid within the timeout defined by Quadro’s administrator, during which hold music (if configured)
will be played to the parked party. Contact your system administrator if you need the call parking timeout to be modified. When the
Call Park timeout expires, a short ring notification will be sent to the phone initiating the call parking, and if no one picks up the
parked call or if the phone is off the hook, the parked call will be automatically disconnected.

For PBX services on IP phones accessible during the call, refer to the “Quadro Features on Epygi Supported IP phones” and “Quadro
Features on Epygi Tested IP phones” documents on the Epygi’s Web portal.
Outgoing Call Blocking

Outgoing Call Blocking
(available on the dial tone)
Insert the extension’s password and press 

Enable Outgoing Call Blocking

Disable Outgoing Call Blocking
Dial a Called Number
to be blocked and press

Dial a Called Number
to be unblocked and press

Forwarding Management

Forwarding Management
(when this menu is accessed, the Unconditional Call Forwarding service
is already getting toggled)

Toggle (enable or disable) the Unconditional
Forwarding service again*

Change the Forwarding Number
Dial a new Forwarding Number
and press 
Confirm the new Forwarding Number with 
or press  to dial a new Forwarding Number.
Please Note: Using the Change the Forwarding Number option will change the first entry in the Unconditional Call Forwarding table with Auto
call type to the inserted Forwarding Number. Any other entries with Auto call type, as well as with other call types will not be modified.
* Besides Any Address/Other Addresses entry of the Unconditional Call Forwarding table this toggling also affects all those entries that have Toggle
from Handset option selected. The states of those entries will be set equal to the state of Any Address/Other Addresses entry after toggling.
QuadroM 32x/8L/26x/12Li/26xi; (SW Version 5.2.x) 8