User`s guide

QuadroM 32x/8L/26x/12Li/26xi Manual III: Extension User's Guide Extension User’s Menus
QuadroM 32x/8L/26x/12Li/26xi; (SW Version 5.2.x) 32
Please Note: Even if the Hiding Caller Information service is
enabled, it shall work only for internal PBX calls and SIP calls. If
you call through FXO/ISDN port to a PSTN number, the called
party will still see your caller ID. To hide your caller ID for PSTN
destinations, contact your PSTN operator.
Fig. III-22 Hiding Caller Information page
Incoming Call Blocking
Incoming Call Blocking allows blocking unwanted incoming calls for a Quadro extension. This page provides the necessary settings for incoming
call blocking. It indicates if the service is enabled for the particular caller and whether or not the custom message will be used to inform the caller
about the call being blocked. If the service for the particular caller has been enabled by the administrator and has been stated as protected, the user
cannot disable it.
Please Note: The administrator can protect the service from being disabled by you. Contact the administrator if callers complain that they cannot
reach you.
The Enable Service checkbox selection blocks all calls to the current extension using the corresponding Address listed in the Caller ID Based
Services table where the Incoming Call Blocking service is configured.
The Send Message to Caller Party checkbox is available when the service is enabled and initiates a message to inform the caller that their line has
been blocked. Otherwise, the calling party will be disconnected without notification.
The Restore Default Blocking Message File restores the default incoming call blocking message if another user-defined file has been previously
selected. When the checkbox is selected, the file upload possibility will be disabled.
The Upload New Blocking Message File requires the name of the
desired voice message file. The file needs to be in PCMU (CCITT u-
law, 8 kHz, 8 bit Mono) wave format, otherwise the system will prevent
uploading it and the “Invalid audio file, or format is not supported”
warning message will be received. The system also prevents
uploading if there is not enough space available for the corresponding
extension. You will then receive the “You do not have enough space”
warning.
Browse is used to browse custom voice message used for incoming
call blocking.
The Download Custom Blocking Message File link only appears if
a file has been previously uploaded. The link is used to download the
audio file to the PC and opens a window where the saving location
can be specified.
Fig. III-23 Incoming Call Blocking page