Installation guide

Quadro Manual I: Installation Guide About This Installation Guide
About This Installation Guide
This Installation Guide explains the installation and basic configuration of the QuadroCS
Conference Server. It gives step-by-step instructions to connect the device properly to the
Internet and to attach a PC for administration and configuration. It also describes the basic
configuration of a conference.
Step 1: Installing the QuadroCS explains connection of cables and devices to the
QuadroCS.
Step 2: Configuring the QuadroCS describes the configuration steps necessary to inte-
grate the QuadroCS into your network environment.
Please Note: The QuadroCS configuration described in this Installation Guide ex-
plains basic networking configurations. For more complex network environments,
please refer to the QuadroCS Administrator's Manual.
Step 3: Registering on Epygi’s Technical Support Before a QuadroCS conference can be
registered on the Epygi SIP server, you must be registered with Epygi Technical
Support. This section shows you how to gain access to the Epygi Technical Support
Center and the Epygi SIP Server. If no SIP registration is needed, skip to Step 5.
Step 4: Registering a Conference on Epygi’s SIP Server explains how to register a SIP
conference.
Step 5: Configuring a Conference on the QuadroCS describes how a conference is set
up on the QuadroCS
Appendix: PC DHCP Settings explains how to configure your PC to access the
QuadroCS configuration GUI.
Appendix: Changing the Administrator's Password explains how to change the default
administrator password.
QuadroCS (SW Version 3.0.x) 5