Installation guide

Quadro Manual I: Installation Guide Step 5: Configuring a Conference on the QuadroCS
The Moderator Password sets a password for the moderator to access the confer-
ence. The moderator is able to use conference codes during the active conference as
well as to access conference-specific GUI pages to coordinate the conference.
Participant Password sets a password for participants to access the conference. The
participant is able to participate in the conference only according to the permissions
granted (speaker or listener). The participant also can access a conference specific
GUI and to view the conference’s properties.
Enable Routing Mode enables dialing according to the dial plan configured in the
QuadroCS call routing tables when dialing out a participant during a conference. When
this checkbox is selected, any dialed number will be parsed through the Call Routing
Table (see Manual II: Administrator's Guide). For this conference example, this check-
box remains unchecked
Leave Active allows the conference to remain active even if all participants have left.
Next displays the second page of the Conference Wizard, the Conference SIP Regis-
tration Settings page:
Fig. I-21: Conference SIP Registration Settings page
4. This page only is needed if the conference is registered on a SIP server (how to regis-
ter a conference on the Epygi Sip Server).
Registration Password indicates the password for the extension registration on a SIP
server.
Registration SIP Server indicates the host address of the SIP server (either an IP ad-
dress, (e.g., 192.168.0.26) or a host address, (e.g., sip.epygi.com)).
Registration SIP Port indicates the host port number to connect to the SIP server. If
the SIP server port is not specified, the QuadroCS will access the SIP server through
the default port 5060.
Registration on SIP Server enables the conference registration on the SIP server.
QuadroCS (SW Version 3.0.x) 22