Installation guide

Quadro Manual I: Installation Guide Step 2: Configuring the QuadroCS
5. Disabling the firewall is only required to access the QuadroCS’s management when the
QuadroCS is connected behind a router. To configure the firewall, open Firewall/Nat
Settings from the Uplink Settings menu. Disable the firewall by deselecting the corre-
sponding checkbox.
Fig. I-13: Firewall Configuration page
The Internet connection is properly configured now and you can start generating the first
conference. If this conference will be registered on a SIP server, you have to do that first,
as you will need the SIP Registration information to generate a conference on the
QuadroCS.
As a default there is one conference that is pre-configured on the QuadroCS and the Epygi
SIP server to register automatically.
If you want to use the Epygi SIP Server to register your conference, you have to register at
Epygi Technical Support first (see next step below) to get a login to the Epygi SIP server.
Then the conference may be registered (see step 4) and finally can be set up on the
QuadroCS (see step 5).
If you do not require registration of your conference, skip to
Step 5: Configuring a Confer-
ence on QuadroCS.
QuadroCS (SW Version 3.0.x) 16