Installation guide

Quadro Manual I: Installation Guide Step 1: Installing the QuadroCS
Connecting the Hardware
• QuadroCS behind a router
Fig. I-5: Installation: QuadroCS behind a router
• QuadroCS directly connected to the Internet
Fig. I-6: Installation: QuadroCS directly connected to the Internet
• Verify the product package contents are complete. Refer to the contents sheet included
in the packaging to determine if all the items were shipped in the box.
• Before you connect the hardware, make sure that all devices are powered off.
Connect the Ethernet port on your PC via a straight CAT 5 cable with an RJ-45 connec-
tor to the LAN socket of the Quadro. If a hub or switch is connected between the
QuadroCS and your PC, us
•
e a crossover cable from the LAN interface of the
•
QuadroCS to the hub/switch.
• Connect the WAN port of the QuadroCS to the Internet service.
Connect the power adapter to the POWER port on the QuadroCS’s rear panel and plug
the power adapter into a power outlet. Only use the original pow
er adapter and plug it
into a power strip with surge protection or to a UPS if available.
The red LED (Fault) will glow for several seconds followed by the yellow LED (Info),
which will glow for several minutes. A
s soon as Info is off, the QuadroCS is operational.
Power up any PC on the LAN side.
QuadroCS (SW Version 3.0.x) 10