User Manual
Table Of Contents
- Product Description:
- The screen material included is our award winning ISF Certified Polar Star® which is a front projection material, precisely formulated for environments with minimal control over room lighting. It was designed to enhance picture brightness, offer accurate color fidelity, and improve contrast levels. The Polar Star® is best for family rooms, educational facilities, conference rooms, house of worship or any applications in which incident light is a factor.
JA050218 www.epvscreens.com 4
Screen Material
Step 6. Secure the elbow joints by fastening them with 4 M4x6 screws (4 at each corner).
Do no tighten completely until all frame pieces are assembled correctly.
Step 7. Carefully unroll the screen material from the roller from one side of the frame to the other side as shown
below.
Step 8. With one end of the spring and secure inside the groove of the frame, hook the spring to the hole located
on the screen material’s outer edge. Use the pull hook when necessary. Attach the four corners first (1). After
those are secure, connect the vertical portions of the material, begin in the center and move towards the corners
(2). Lastly, connect the horizontal sections of the material by connecting the center of the material and make
your way towards the corners (3).
Step 9. Insert the Center Support Bar into the upper top groove on the back of the frame (not the one where the
spring inserts) with the bottom end near the approximate center point of the frame. Rotate it in at an angle so
that both ends of the bar are in alignment with the groove. (See illustrations below for details)
Diagonal Models 150” and below use
1 x Center Support Bar
Diagonal Models above 150” require 2 x
Center Support Bars
Front Side