User Manual

JA-022818 www.EPVscreens.com 6
Center Support Bar Installation
1. Insert the Center Support Bar into the upper top groove on the back of the frame (not the one where
the fix plate inserts) with the bottom end near the approximate center point of the frame and rotate it in at an
angle so that both ends of the bar are in alignment with the groove (see Fig. 17 below for details).
Diagonal models bleow 165” use 1 x Center Support Bar
Diagonal models 165” and above require 2x Center Support Bars
2. Slide the top end of the bar into the top center point of the frame to complete the center support bar
installation. This will provide added stability to your frame and added tension to the material.
Screen material edge
Center Support Bar
(Fig. 17)
Remove
push
Center Support Bar
Fixed plate groove
(Do not insert here)