User Manual

Rev.082416-MZ
INSTALLATION
INSTRUCTIONS
1.
Locate your desired installation location with a stud finder (recommended) and mark the
where the screen is to
be installed
2. Drill a hole
with the proper bit size according to the wood screw
3. Line up the wall brackets
with the drilled holes on the installation location and screw them
screwdriver.
Note: Use 2 top wall brackets on diago
diagonal sizes 135” and above
4.
Position the fixed frame screen onto t
bottom frame
to secure the installation.
5.
The wall brackets allow flexibility
feature as it allows your screen
to be
6.
Using both hands finish the installation by pushing the lower portion of the fixed
bracket as shown in Fig 21.
For a local Elite Screens contact or Technical Support, please visit
(Fig.
20
7
INSTRUCTIONS
Locate your desired installation location with a stud finder (recommended) and mark the
be installed
.
with the proper bit size according to the wood screw
s included.
with the drilled holes on the installation location and screw them
Note: Use 2 top wall brackets on diago
nal sizes below 135”, and use 3 top wall brackets on
Position the fixed frame screen onto t
he top wall brackets as shown (Fig. 20)
and push down at the center of the
to secure the installation.
The wall brackets allow flexibility
by allowing the fixed frame
screen to slide to the sides.
to be
properly centered.
Using both hands finish the installation by pushing the lower portion of the fixed
frame screen into the lower
For a local Elite Screens contact or Technical Support, please visit
www.EPVscreens.com
20
)
www.EPVscreens.com
Locate your desired installation location with a stud finder (recommended) and mark the
drill-hole area of
with the drilled holes on the installation location and screw them
in using a Philips
nal sizes below 135”, and use 3 top wall brackets on
and push down at the center of the
screen to slide to the sides.
This is an important
frame screen into the lower
For a local Elite Screens contact or Technical Support, please visit
(Fig. 21)