User Manual

Rev.082416-MZ 6 www.EPVscreens.com
2. Insert the Center Support Bar into the upper top groove on the back of the frame (not where the fix plate inserts)
with the bottom end near the approximate center point of the frame and place it in at an angle so that both ends of the
bar are in alignment with the groove(Fig. 18 and 19).
Diagonal models 150” and below use 1 x Center Support Bar
Diagonal models above 150” require 2 x Center Support Bars
3. Slide the top end of the bar into the top center point location to complete center support bar installation. This will
provide added stability to your frame and added tension to the material.
Screen material edge
Center Support Bar
(Fig. 18)
Fixed plate groove
(do not insert here)
Remove
push
Center Support Bar
(Fig. 19)