Operation Manual
1. Access Web Cong and select Scan/Copy or Fax tab > Presets.
2. Select the registered number and click Edit.
3.
Select Type.
Note:
If you want to change the Ty pe aer registering, delete the registered preset and then register it again.
4. Click Next.
5.
Set up each item.
Enter a Name between 1 and 30 characters in Unicode (UTF-8).
6. Click OK.
If the combination of the value is invalid, a valid value that is automatically modied is applied.
Related Information
&
“Accessing Web
Cong
” on page 28
Backing Up the Settings
You can export the setting value set from Web Cong to the le. You can use it for backing up the contacts, setting
values, replacing the printer, etc.
e exported le cannot be edited because it is exported as a binary le.
Export the settings
Export the setting for the printer.
1. Access Web Cong, and then select the Device Management tab > Export and Import Setting Value >
Export.
2. Select the settings that you want to export.
Select the settings you want to export. If you select the parent category, subcategories are also selected.
However, subcategories that cause errors by duplicating within the same network (such as IP addresses and so
on) cannot be selected.
3.
Enter a password to encrypt the exported le.
You need the password to import the le. Leave this blank if you do not want to encrypt the le.
4.
Click Export.
c
Important:
If you want to export the printer’s network settings such as the device name and IPv6 address, select Enable to
select the individual settings of device and select more items. Only use the selected values for the replacement
printer.
Administrator's Guide
Operation and Management Settings
97