Operation Manual
Setting Server Mode
To use Document Capture Pro Server, set up as follows.
1. Access Web Cong and select the Scan/Copy tab > Document Capture Pro.
2.
Select Server Mode for Mode.
3. Enter the address of the server with Document Capture Pro Server installed on it for Server Address.
Enter between 2 and 255 characters in either IPv4, IPv6, host name or FQDN format. For FQDN format, you
can use alphanumeric characters in ASCII (0x20-0x7E) and "- " except for at the beginning and end of the
address.
4. Click OK.
e network is re-connected, and then the settings are enabled.
Related Information
& “Accessing Web Cong” on page 28
Making System Settings
Setting the Control Panel
Setup for the printer's control panel. You can set up as follows.
1. Access Web
Cong
and select the Device Management tab > Control Panel.
2. Set up the following items as necessary.
❏ Language
Select the displayed language on the control panel.
❏ Panel Lock
If you select ON, you cannot select items that require the administrator's authority. To select them, log in to
the printer as the administrator. If the administrator password is not set, the panel lock is disabled.
❏ Operation Timeout
If you select ON, when you log in as the access control user or administrator, you are automatically logged
out and go to the initial screen if there is no activity for a certain period of time.
You can set between 10 seconds and 240 minutes by the second.
Note:
You can also set up from the printer’s control panel.
❏ Language : Settings > General Settings > Basic Settings > Language
❏ Panel Lock : Settings > General Settings > System Administration > Security Settings > Admin Settings > Lock
Setting
❏ Operation Time Out : Settings > General Settings > Basic Settings > Operation Time Out (You can specify On or
O.)
Administrator's Guide
Function Settings
73