Operation Manual
USB I/F Timeout Setting:
is
item is displayed on PCL or PostScript compatible printer.
Specify the length of time in seconds that must elapse before ending USB communication with a
computer aer the printer receives a print job from a PostScript printer driver or PCL printer driver.
If the job ending is not clearly dened from a PostScript printer driver or PCL printer driver, it can
cause endless USB communication. When this occurs, the printer ends communication aer the
specied time has elapsed. Enter 0 (zero) if you do not want to end communication.
Network Settings
Select the menus on the control panel as described below.
Settings > General Settings > Network Settings
You cannot change settings that have been locked by your administrator.
Wi-Fi Setup:
Set up or change wireless network settings. Choose the connection method from the following and then
follow the instructions on the LCD panel.
❏ Router
❏ Wi - Fi D i r e c t
Wired LAN Setup:
Set up or change a network connection that uses a LAN cable and router. When this is being used, Wi-
Fi connections are disabled.
Network Status:
Displays or prints the current network settings.
❏ Wi r e d L A N / Wi - F i St a t u s
❏ Wi - Fi D i r e c t S t a t u s
❏ Print Status Sheet
Connection Check:
Checks the current network connection and prints a report. If there are any problems with the
connection, see the report to solve the problem.
Advanced:
Make the following detailed settings.
❏ Device Name
❏ TCP/IP
❏ Proxy Server
❏ IPv6 Address
❏ NFC
❏ Link Speed & Duplex
❏ Redirect HTTP to HTTPS
Administrator's Guide
Appendix
91