Operation Manual

2. Select Router.
e network status is displayed.
3. Select Change Settings.
4. Select Others > Disable Wi-Fi.
5. Check the message, and then start setup.
6. When a completion message is displayed, close the screen.
e screen automatically closes aer a specic length of time.
7. Press the
button.
Disconnecting Wi-Fi Direct (Simple AP) Connection from the Control Panel
Note:
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in Wi-Fi
Direct (Simple AP) connection are disconnected. If you want to disconnect a
specic
device, disconnect from the device
instead of the printer.
1. Select Wi - F i on the home screen.
To select an item, move the focus to the item using the
u d l r buttons, and then press the OK button.
2. Select Wi - Fi D i r e c t .
e Wi-Fi Direct information is displayed.
3. Select Change Settings.
4.
Select Disable Wi-Fi Direct.
5. Check the message, and then start setup.
6. When a completion message is displayed, close the screen.
e screen automatically closes aer a specic length of time.
Restoring the Network Settings from the Control Panel
You can restore all network settings to their defaults.
1. Select Settings on the home screen.
2. Select General Settings >System Administration >Restore Default Settings > Network Settings.
3. Check the message, and then select Ye s .
4.
When a completion message is displayed, close the screen.
e screen automatically closes aer a specic length of time.
Administrator's Guide
Solving Problems
75