Operation Manual

Items Settings and Explanation
Remote Gateway(Tunnel
Mode)
If you select Tunnel Mode for Encapsulation, enter a gateway address between 1 and 39
characters.
Security Protocol
If you select IPsec for Access Control, select an option.
ESP Select this to ensure the integrity of an authentication and data,
and encrypt data.
AH Select this to ensure the integrity of an authentication and data.
Even if encrypting data is prohibited, you can use IPsec.
Algorithm Settings*
IKE Encryption Select the encryption algorithm for IKE.
The items vary depending on the version of IKE.
Authentication Select the authentication algorithm for IKE.
Key Exchange Select the key exchange algorithm for IKE.
The items vary depending on the version of IKE.
ESP Encryption Select the encryption algorithm for ESP.
This is available when ESP is selected for Security Protocol.
Authentication Select the authentication algorithm for ESP.
This is available when ESP is selected for Security Protocol.
AH Authentication Select the authentication algorithm for AH.
This is available when AH is selected for Security Protocol.
* For Algorithm Settings, it is recommended that you select Any for all settings or select an item other than Any
for each setting. If you select Any for some of the settings and select an item other than Any for the other settings,
the device may not communicate depending on the other device that you want to authenticate.
Related Information
&
“
Conguring
Group Policy” on page 115
&
“Combination of Local Address(Printer) and Remote Address(Host) on Group Policy” on page 119
& “References of Service Name on Group Policy” on page 120
Combination of Local Address(Printer) and Remote Address(Host) on Group
Policy
Setting of Local Address(Printer)
IPv4 IPv6* Any addresses*
Setting of Remote
Address(Host)
IPv4* ✓ – ✓
IPv6** – ✓✓
Blank ✓✓✓
Administrator's Guide
Advanced Security Settings for Enterprise
119