Operation Manual

3. Slide the switch while holding down the button and hold them there for approximately 10 seconds until
the ready light ashes to turn on the scanner.
c
Important:
You must complete Wi-Fi connection setup within two minutes.
4. Use your computer to enter the PIN code (an eight-digit number) on the label stuck to the scanner.
Connection setup starts. e Ready light ashes, and the
and lights on the scanner ash alternately.
When the Ready light,
and lights stay on, connection is complete.
Note:
❏ For details on entering a PIN code, see your router documentation for instructions.
❏ Connection has failed when the Ready light stays on,
and lights ash simultaneously. Restart the scanner
and the router, move them closer together, and then try again.
Related Information
& “Basic Scanning” on page 38
& “Advanced Scanning” on page 54
& “Network Problems” on page 82
Making Wi-Fi Direct (Simple AP) Connection Settings
is method allows you to connect the scanner directly to devices without a wireless router. e scanner acts as a
router.
c
Important:
When you connect from a smart device to the scanner using a Wi-Fi Direct (Simple AP) connection, the scanner is
connected to the same Wi-Fi network (SSID) as the smart device and communication is established between them.
Since the smart device automatically connects to other connectable Wi-Fi networks when the scanner is turned
o,
it
does not connect to the previous Wi-Fi network again when the scanner is turned on. Connect to the scanner’s SSID
in Wi-Fi Direct (Simple AP) from the smart device again. If you do not want to connect every time you turn the
scanner on or
o,
we recommend using a Wi-Fi network by connecting the scanner to a router.
1. Set the switch on the scanner to on.
User's Guide
Network Settings
23