Operation Manual

3. Hold down the WPS button on the router until the security light ashes.

Important:

You must complete Wi-Fi connection setup within two minutes.

If your router does not have a WPS button, see your router documentation for instructions on enabling WPS

in your router's soware.

Hold down the

button on the scanner until the Ready light

ashes,

and and lights

ash

alternately (approximately 3 seconds).

When the Ready light,

and lights stay on, connection is complete.

Note:

Connection has failed when the Ready light stays on,

and lights ash simultaneously. Restart the scanner and

the router, move them closer together, and then try again.

Related Information

& “Basic Scanning” on page 38

& “Advanced Scanning” on page 54

& “Network Problems” on page 82

Making Wi-Fi Settings by PIN Code Setup (WPS)

You can automatically connect to a wireless router by using a PIN code. You can use this method to setup if the

router supports WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the router.

1. Make sure that the scanner is turned o.

2. Set the

switch on the scanner to on.

User's Guide

Network Settings