User Manual

Light status Condition/solution
The ready light and the The scanner firmware is updating. Do not turn off the scanner or
disconnect any cables until the status lights have stopped flashing.
Wi-Fi light are flashing
alternately
The product is in a standby state for a Wi-Fi Protected Setup (WPS)
connection.
The ready light and the A paper is jammed. Reload the original. If the lights continue to flash, a
scanner error may have occurred. Turn the scanner off and then back
Wi-Fi light are flashing at
on again. If the error continues, contact Epson for support.
the same time
An AOSS error has occurred. Retry the connection.
The Wi-Fi light is flashing
The low battery light is The batteries are running low. Make sure you have replacement
on batteries available.
Parent topic: Solving Problems
Solving Scanning Problems
Check these solutions if you have problems scanning with your product.
Scanner Does Not Turn On or Turns Off Unexpectedly
Scanner Button Does Not Work as Expected
Scanning Software Does Not Operate Correctly
Cannot Start Epson Scan
Original Feeds Incorrectly in Scanner
Original Jams in Scanner
Scanning is Slow
Parent topic: Solving Problems
Scanner Does Not Turn On or Turns Off Unexpectedly
If the scanner does not turn on or if it turns off unexpectedly, try these solutions:
• Make sure the optional AC adapter is securely connected to the scanner and to a working electrical
outlet.
• If the scanner turns off unexpectedly, you may need to adjust the Power Off Timer setting.
• Try pressing the power button for approximately one second.
• If you are using a USB connection, make sure the connection mode switch is set to USB.
61